Balanceable Toolholders
Balance In Under 3 Minutes
Typical Screw Balance System
- Typical straight screw design takes 15 minutes or more to balance.
- Often requires removal or exchange of Screws to accommodate limited adjustment.
- Short course thread provide poor adjustment resolution.
- Centrifugal forces try to project the adjustment screw from the tool holder or dislodgment under high rotational speeds.
Parlec’s Patented Radial Offset Balancing System
- Radical Offset nylon patch screws makes balancing in under three minutes possible.
- No screw removal or loose balls or weights to manage.
- Radial Offset increases the screws pitch for best adjustment resolution.
- Centrifugal force applies radial pressure on the screw preventing any movement or dislodgment under high rotational speeds.
